CIFA# 24852 / PeopleSoft ID: 1067825
The Fluke Pro3000 Analog Tone & Probe Kit tones and traces wire. The Pro3000 Analog Tone and Probe is your best choice for toning and tracing wire on non-active networks, and specifi?cally for identifying individual pairs with SmartTone? technology.
Angled bed-of-nails clips allow easy access to individual wires, and the RJ-11 connector is ideal for use on telephone jacks. The large loud speaker on the probe allows you to hear through drywall, wood or other enclosures to find wires quickly and easily.
You can send this loud tone up to 10 miles (16 kilometers) on most cables! Attach the nylon pouch to your belt, and you will be equipped for any wire identification job.
Tone and trace wire on non-active networks
SmartToneTM technology provides five distinct tones for exact pair identification
Loud speaker on Probe makes the tone easier to hear through drywall, wood, and other enclosures
Angled bed-of-nails clips allow easy access to individual pairs
Attach nylon pouch (included in kit) to your belt for easy transport
Sends loud tone up to 10 miles (16 kilometers) on most cables
RJ-11 connector is ideal for use on telephone jacks
Solid Frequency: 1000 Hz nominal
Alternating Frequency: 1000/1500 Hz nominal
Over Voltage Protection: 60 Vdc in Toner/Polarity Mode
Output Power in Tone Mode: 8 dbm into 600 ohms
Output Voltage Level in Continuity Mode: 8 Vdc with fresh battery
Battery: 9V alkaline
Fluke Networks PRO3000 Instruction Manual