So far, this Product Review was helpful to 2 TTS Customers.
Works good, needs a way to keep it from sliding
July 15, 2018
Bill Hoagland from Pittsburgh, PA United States
Works as stated, not sure how it stays in place on the drill bit shaft, rubber bushing or magnetic, but a stronger holding power would be a very good improvement. The product slid down the shaft several inches allowing the bit head to veer off target a little not enough to ruin the work. But the more the product slides down the shaft the risk increases. If the metal sleeve was extended a half inch a set screw could be a good fix to this problem, now I'm using duct tape around the shaft below the ball to keep it from sliding.
Was this review helpful to you?
So far, this Product Review was helpful to 1 TTS Customers.