Adding one more board to a finished control panel usually means the bad options: drill the backplane (metal shavings near live electronics), adhesive standoffs (until summer), or a whole new panel build.
The Mag-Daddy PCBM100 offers the good option: magnetic standoffs with a rated-and-tested 10 lb neodymium base that snap hardware onto any steel panel surface — no drilling, no shavings, no downtime.
Each standoff pairs the magnet mount with a bayonet snap-lock PCB support, so boards click on and off for service access in seconds.
That serviceability is the everyday win: panel builders and technicians can add hardware, rearrange layouts to fit the job rather than the panel box, and get quick repair access without ever touching a drill. Standoffs keep the mounted board at a safe distance from the panel surface for air circulation and short-circuit prevention — exactly what PCB mounting requires.
The 12-piece kit uses 3/4" (19 mm) N35M magnet mounts with a 0.193" (4.9 mm) hole size, HHCBS-12 (0.75") screw-and-lock PCB supports in V-0 flame-rated natural nylon, and 6-32 x 3/8" hardware.
A cost-effective retrofit that turns any steel enclosure into a reconfigurable mounting surface.
Features:
- Neodymium magnets rated and tested at 10 lb pull strength
- Bayonet snap-lock PCB supports — boards click on/off for fast service access
- No drilling: no metal shavings in the panel, no downtime
- Add, remove, and rearrange hardware to fit the job, not the panel box
- Maintains standoff spacing for air circulation and short prevention
- V-0 flame-rated support material
Specifications:
- Model: Mag-Daddy PCBM100
- Magnet: N35M neodymium, 3/4" (19 mm), 10 lb pull (rated & tested)
- PCB Support: Screw-and-lock bayonet, HHCBS-12 (0.75"), V-0 natural
- Hole Size: 0.193" (4.9 mm)
- Hardware: 6-32 x 3/8" Phillips
- Quantity: 12 pieces
Skip to content
