So far, this Product Review was helpful to 0 TTS Customers.
Arlington Siding Mounting Kit
August 4, 2020
Reviewer:
Craig Hamrick from Macomb, IL United States
These are absolutely the easiest way to mount fixtures! Well made and so easy to install. 5 stars !!!!
Was this review helpful to you?
So far, this Product Review was helpful to 0 TTS Customers.
easy!
July 3, 2020
Reviewer:
maryellen halloran from wakefield, RI United States
This was perfect to install a light fixture with a 6x8in base. My siding has 4inches exposed and it was a breeze to install.
Was this review helpful to you?
So far, this Product Review was helpful to 0 TTS Customers.
Arlington Mounting Kit
June 12, 2019
Reviewer:
Jay S from Apple Valley, MN United States
Great product! Great coverage, easy install and fit. I used as a retro fit over my old smaller mounts with new outside LED lights.
Was this review helpful to you?
So far, this Product Review was helpful to 0 TTS Customers.
Tweak Works on Hardiplank
May 14, 2019
Reviewer:
Rod G from Apex, NC United States
The product is designed for a 5" shingle, but Hardiplank is 7". Just had to sand down the lower lap interface by about 1/4" to get the right fit; then caulk the edges. Looks great! Installation was mere minutes ...
Was this review helpful to you?
So far, this Product Review was helpful to 1 TTS Customers.
No Hole in Existing Walls
November 6, 2018
Reviewer:
STEVEN from Fuquay Varina, NC United States
This is the third set of these I have purchased. Although these are best for remodel lighting it is also great for New Construction. These are designed for D4 (4/4) vinyl siding - so if you have a D4.5 there is going to be a gap at that next overlap but this is minimal compared to fitting a new box into an existing wall. Planning for the exact height of an outside light is a two person effort. One holds and the other sez - "there - right there". That doesn't work so well when you can't see it next to a door or garage or back porch and the fact that the only hole you have is for the 14/2 wire to pull thru the vinyl siding into the mount makes it a cinch for wiring. Screw this onto wall and place your lights' back support onto the mount and mount your light. Done. Simple.
Arlington Siding Mounting Kit 
