The PPC PP625P3 is the .625 P3 companion to PPC's 2-piece hardline pin connector family — trunk-and-feeder hardware engineered for what digital cable networks actually demand.
Built to fit .625 P3 cable from all major CATV manufacturers, it meets or exceeds all SCTE specifications and carries PPC's signature advantage: reusability. During routine and most emergency maintenance the connector comes off and goes back on without damage, which on amp and node-heavy .625 plant is genuine money over the life of the system.

The electrical spec sheet reads like the 500-size twin, and that's the point.
Bandwidth 0 MHz to 1 GHz at 75 ohms, return loss better than -30 dB to 1 GHz, insertion loss under 0.10 dB to 1 GHz — and for powered plant, a 90-volt, 20-amp continuous AC rating that carries system power through the connection reliably. Operating range spans -40°F to +140°F.

Installation is standard 2-piece practice: two 7/8" wrenches, a pin cutter, and your .625 prep tool.
The connector presents a 1.000" nominal hex and a 0.137" center conductor pin for the equipment port. Running .500 too? We stock the matching PP500P3 — same family, same reusability, one truck standard.

• 2-piece pin connector for .625 P3 hardline cable
• Reusable without damage through routine and most emergency maintenance
• Meets or exceeds all SCTE specifications; fits all major CATV cable makers' .625 P3
• 90 V / 20 A continuous AC power passing
• Performance to 1 GHz for high-speed data, video, and telephony

• Model: PPC PP625P3
• Cable: .625 P3 hardline
• Bandwidth: 0 MHz - 1 GHz
• Impedance: 75 Ohm
• Return Loss: Better than -30 dB to 1 GHz
• Insertion Loss: Less than 0.10 dB to 1 GHz
• Power Rating: 90 V, 20 A @ 60 Hz continuous AC
• Hex / Pin: 1.000" nominal hex; 0.137" center conductor
• Operating Temp: -40°F to +140°F
• Install Tools: Two 7/8" wrenches, pin cutter, cable prep tool